Need Help Tunze 6100's and 7094 Multi Controller

[Adamc1303]

I am trying to set this up to the sequential pump circuit. The issue is that the powerhead on the 2nd channel is not turning on. It will spin for just 1 second and then stop. I followed the exact directions from the controllers manual. I know there is nothing wrong with the pumps because they run just fine in the other modes. I just got this setup I am also confused with the function of the dial near interval #5 dial in the manual. Any help will be greatly appreciated.

 

[Adamc1303]

anyone?

 

[rvitko]

How many pumps do you have? If you have only two sequential doesn't work to well. You will use the first and last socket in that case.

 

[Adamc1303]

I am using 2 pumps I got it to work, but I haven't figured out how to set up the time between each pump.

 

[Adamc1303]

I am using 2 pumps I got it to work, but I haven't figured out how to set up the time between each pump.

 

[SFreefer]

I am in a similar situation. I have the same setup but am trying to do the Automatic interval operation or “Low and high tide” mode. I have one pump plugged into #8 and another plugged into 11. They both run at the same time no matter what I try. I also don't get the LED (16) to light up red. It does light up green though.

Any suggestions appreciated.

 

[rvitko]

Adamc, the time is generally set with the switch and the knob sets the time within the range set by the switch, however, sequential with 2 pumps does not work very well and it can be difficult to set, this mode is generally intended for use with 4+ pumps.

The LED was green in later models. Do the pump LEDs operate correctly showing 8,10 and 9, 11 on?