Need help with Gen 2 pump

[dancewithethan]

I gave my power-head a cleaning today, and put the control unit on feed mode so I can remove the pump. However, when I put the pump back into the tank, the control unit light blink RED, and my pump stop. I've try to unplug the power cord, and reconnect, the pump runs, but the control unit goes back to blinking RED and the pump stop again. what went wrong and what can I do. please help.

 

[EcoTech Marine]

You may have inadvertantly calibrated the pump. To reset this hold mode to enter feed mode (the pump blinks white), then hold mode and set to enter calibration mode (the pump blinks white/yellow). Next cycle power to the pump by unplugging and re-plugging it in. This should solve your problem.

-Tim

 

[dancewithethan]

it works now, thank you