Need your input on pluming

[plc001]

All,

I have a 90G that I want to re-do all the pluming. I goal is to move enough water to keep SPS happy but it is a mix tank. I currently have:

PCX Gen-X 30 for the main pump from sump to tank
Little Giant 2MD-SC for a PhosBan Reactor (sp) and from sump to tank
MaxiJet 1200, Seio M620 and Seio M1100 for circulation.

I do not mind getting all new pumps and start from scratch and I could go with internal or external pumps.

If you were to do it again, what would you do?

Thanks!

 

[Northtampatang]

That a good bit of flow through a phosban reactor!

I dont know what your actual plumbing looks like, but if it is not a nightmare, you could probably just pop in another seio 1100 in exchange for the Maxi jet.

You dont want a super high turnover rate through your sump, so in tank turnover should be your goal.

If you have the extra money, get a Tunze.


*this is just my 2c*

 

[plc001]

Thanks for the input. The phosban reactor is not getting that much flow, I tee of to the main tank. I'm moving the tank to be in-wall so I have the opportunity to re-do everything. I want to have my in-wall set up ready before I take down my current tank and my current tank pluming is a mess, no valves, no way to clean the pumps. My pumps have been running 24/7 with no maintenance for way too long.

That is why I want to re-do the whole thing. The good thing is that I'm open for anything.

Thanks again.