No Outlets Showing On Status Page

[Tortuga78]

Just got an Apex and spent most of the day learning how to program it with the help of Alan's helpful manual. As is usually the case, when I work on something too long, I think I screwed something up. When I log into my Apex through my network, the status page shows only Temp, PH & OPR but no outlets. When I go to Outlet Setup under Configuration, I get a blank setup page with no pull down menu for Outlet. Under Profiles Setup, everything looks fine, all my custom profiles are still there. Also, all my modules are identified under the Module Setup page.
I powered down the system thinking maybe it was a glitch but still no outlets showing.
Here is where I believe I screwed up. Before losing my outlets, I was checking out the Load/Save page under Configurations. My intentions were to save my programming. I selected "All Configurations" and instead of selecting "Save" I think I selected "Restore Configuration". I had not done any kind of save prior to this action.
Would this cause my outlets to erase? I would think my profiles would have erased as well. I would also think that restore would have taken everything back to the original state such as original outlet and profile names (manufacturer's default).
Hopefully someone out there has a simple answer to getting my outlets back and I don't have to recreate every outlet from scratch.
Thanks in advance

 

[swearint]

That sounds plausible. You may need to contact Neptune to get an answer. I would expect that no apexcfg.bin file exists prior to saving one for the first time and the restore would not execute. So, this may be a bug.

Todd

 

[Tortuga78]

Thank you Todd. I ended up doing a Initialize Memory from the controller and it brought everthing back to the original default. All the outlets are showing, I just have to reprogram and rename. (I can use the practice)