Krakonosh
New member
Hi Roger,
I just purchased two 6205's, replacing older 6101's. The wider flow is great, but the noise is terrible. Sounds like hammer-drilling when at above 60%.
I tried holding the pumps in my hand, no diff. I disassembled them for inspection and it appears fine.
I read in earlier posts that there is a thicker shaft available.
How can I get a hold of few of these ?
I don't think the new holder brackets are going to help me much.
It looks like the impeller is out of balance, the life span will most likely be very short and there is definitely few hundreds of millimeter play on the shaft.
Thanks.
Denis M.
I just purchased two 6205's, replacing older 6101's. The wider flow is great, but the noise is terrible. Sounds like hammer-drilling when at above 60%.
I tried holding the pumps in my hand, no diff. I disassembled them for inspection and it appears fine.
I read in earlier posts that there is a thicker shaft available.
How can I get a hold of few of these ?
I don't think the new holder brackets are going to help me much.
It looks like the impeller is out of balance, the life span will most likely be very short and there is definitely few hundreds of millimeter play on the shaft.
Thanks.
Denis M.