How do you do it?!?!? I purchased an Aqua Euro USA CL-150 chiller. When I opened the box, I expected some sort of step-by-step booklet, but all it had was a sheet that didn't describe how to install it in detail at all. Basically, it just said the following:
1. Remove chiller and accessories from box.
2. Place chiller on stable, flat, even surface in an area that will receive good ventilation and allow air flow.
3. Do no store in closed location that does not receive air flow.
4. Assemble inlet and outlet plumbing fittings and connect to the chiller.
5. Connect external flexible hoses to the inlet and outlet, tighten the clamp collar so that hoses do not disconnect while chiller is in use.
6. Before turning chiller on, once all connections are made, filter the aquarium water before using the chiller to avoid obstruction and ensure proper heat exchange. Circulate water through chiller for 30 minutes before turning the unit on. Check all connections for water leakage and/or obstruction. Check pump is operational and unblocked.
That's all it said for set up.
Any help out there?
1. Remove chiller and accessories from box.
2. Place chiller on stable, flat, even surface in an area that will receive good ventilation and allow air flow.
3. Do no store in closed location that does not receive air flow.
4. Assemble inlet and outlet plumbing fittings and connect to the chiller.
5. Connect external flexible hoses to the inlet and outlet, tighten the clamp collar so that hoses do not disconnect while chiller is in use.
6. Before turning chiller on, once all connections are made, filter the aquarium water before using the chiller to avoid obstruction and ensure proper heat exchange. Circulate water through chiller for 30 minutes before turning the unit on. Check all connections for water leakage and/or obstruction. Check pump is operational and unblocked.
That's all it said for set up.
Any help out there?
