Osmolator Problem

[mnkstr1]

I had red blinking light this morning. Unplugged the osmolator to reset it and none of the leds would light up. If I wait long enough, the blinking red led will eventually come back. Any ideas?

 

[rvitko]

Try disconnecting the pump, check the pump connection for any water or salt damage. See if it runs normally in terms of controller lights when the pump is removed.

 

[mnkstr1]

Disconnected the pump. The green led illuminates just fine. But when the water level is low, the yellow led that signals for the pump to come on is really dim. I could barely tell it was illuminated.

 

[rvitko]

It sounds like the pump is dead or the wiring from the controller or pump connector is very corroded, this may have damaged the PTC which is essentially a pump kill switch if the pump is shorted or using too much current. Send it in and include your pump and power supply as well as a note about the problem with return address and phone number-

Tunze USA
305 Victor St
Austin TX 78753

 

[jkienzpac]

new osmolator malfunctioning

new osmolator malfunctioning

sorry wanted to place a new thread