Pin spacer adjustment?

[jameshongth]

I just got my MP20 and now trying to figure out how to adjust the pin spacer.

My 2ft RSM's glass thickness is only 8 mm so do I have to adjust it and how to adjust if needed?

Can anyone advice?

 

[EcoTech Marine]

I would adjust it to the 3/8" setting. Instructions for use of the pin spacer are included on the sticker of the pin spacer and in the instruction manual. The sticker can be seen by removing the rubber gasket from the surface of the pin spacer.

-Tim

 

[jameshongth]

Hi Tim,

Yes, i do see the instruction. However, I dun quite understand what it mean?

pull and turn the rubber pin spacer cone to 3/8" to point at the power cord??

 

[Mike31154]

You've got it. The number you want, 3/8" in your case should align with the power cord. Take extra care when sliding it back on to align the pins so they don't get bent.

 

[jameshongth]

<a href=showthread.php?s=&postid=13299364#post13299364 target=_blank>Originally posted</a> by Mike31154
You've got it. The number you want, 3/8" in your case should align with the power cord. Take extra care when sliding it back on to align the pins so they don't get bent.

Thanks Mike.

What is the impact if I have not adjust to the correct pin spacer ?