Plumbing parts for a EuroReef

[MJAnderson]

Does anyone know where to get a tube so I can extend my output 90 degree elbow down into my sump? It's not sch 40 or 80. Is it something special that I can only get from ER? I only need about 2" of pipe to submerge the outlet.

 

[Phyxius]

Which model skimmer? They have 1.25 and 1.50 tubing on the larger ones and they swap them depending on the models. My CS has 1.50 and my RC model has 1.25.....
You could always look on the ER site and see what size they say is on it for repair parts and go from there or post in the ER forum and ask.

 

[raynist]

Re: Plumbing parts for a EuroReef

<a href=showthread.php?s=&postid=13087866#post13087866 target=_blank>Originally posted</a> by MJAnderson
Does anyone know where to get a tube so I can extend my output 90 degree elbow down into my sump? It's not sch 40 or 80. Is it something special that I can only get from ER? I only need about 2" of pipe to submerge the outlet.

When making parts for my Euroreef's in the past I would get fittings that 'almost' fit from HD or Lowes and then use a dremel to bore them out a little. Has worked every time so far. I do run them in the sump though, would not trust them if you run out of the sump.