problems with TUNZE 7096, configuration

[ricardo piza]

Hello guys, okay with you?

I have a controller TUNZE 7096 and 4 pumps TUNZE, but I can not set up to make the movement of waves, how do I setup this?

 

[Craig Borowski]

I would start with one pump on each end of the aquarium. Plug these two pumps in to sockets 3 and 4 of the controller. Turn off all the other pumps. On the 7096 software, check both the Wavecontroller and Inverse boxes. Now push Start by Auto Adjust. Then just watch as the controller automatically increases the timing. It will get to a point where a small wave starts, then the wave will get larger before eventually getting smaller again. You should press stop when it's making a wave and then use the two arrows on the Seconds timer to make fine adjustments.

 

[ricardo piza]

Thanks and sorry Craig, I was wrong, the controller is the 7095

 

[rvitko]

Only the 7092 and 7096 can create an actual wave. The 7095 does not have the required wavemode.