Profilux - Mean Well

[Vannpytt]

Hi,

I'm building a DIY Led with Cree and Mean Well drivers with PVM control signal. I want to use my Profilux controller for this, and need the converter from 1-10V -> PVM wich would be the LEDControl4Passive from what I gather. This one uses L1 and L2 to control 4 separately dimmable Mean Well drivers if I'm not mistaken? (To make 4 individual control zones). If I got 10 controllers (2x48 Ultra Premium kits and 1x24 Ultra Premium kits) would I be able to use 2 Mean Wells on 1 channel to control those two zones, (since I have to buy 3 LEDControl4Passive amounting to 12 channels) I would rather like to get away with 8 separate zones.

So, to clearify the question, can I hook 2 Mean Wells to 1 control signal or do I have to have 1 signal for each driver?

Thanks in advance

 

[luisagos]

I have had 3 Mean Well drivers per 1-10v channel, using the 1-10v mean well driver version.
Also used the Profilux EVG-AP-2F board, made things very neat.

One of the cool feature of this board, if you set the 1-10v to 0, there is a built in relay that will shut off your driver 120v, so your driver will not be on when you do not want the LED to be on, saves on socket space.

Each 1-10v out Profilux channels has the ability to turn on a relay, little secret that even GHL doesn't brag about.

 

[Vannpytt]

Thank you very much! I ordered 2 controllers instead of 3 then. The PVM is also capable of turning off as far as I'm aware.

Looking forward to the build.