Pump & Bulkhead

[ZachB]

Looking for a MaxiJet 1200+ (or any cheap pump that does around 300gph), and a 3/4" thread+ thread, or inner thread+ slip bulkhead. I'm in the Brentwood / Spring Hill area.

 

[andywe]

Zach I have a bulkhead for you. Slip-thread.

 

[ZachB]

Slip inside tank or outside tank?

Zach I have a bulkhead for you. Slip-thread.

 

[ZachB]

Got the bulkhead, now I just need a pump.

Bueller, Bueller...anyone, anyone..

 

[andywe]

SO do you need my bulkhead or not sir? I may have both types...Slip (flange) thread (throat) or thread thread. Let me know if you need one.

 

[ZachB]

SO do you need my bulkhead or not sir? I may have both types...Slip (flange) thread (throat) or thread thread. Let me know if you need one.

I might - not sure yet. I will see if the one I picked up at the critter seals properly, as the diameter of the one I picked up there is a bit smaller than the one I already had. Apparently bulkhead sizes aren't standard even though they're both 3/4"

Will let you know - appreciate it!