My WWD boxes are tucked away behind the stand, and wires are jumbled up, so rather than pulling them out and reprogramming to be sure, I thought I'd double check re color codes first. They are visible, just hard to reach, and I might have bumped some of the buttons yesterday while working on the setup.
One driver shows orange LED. Per the manual, that indicates it's slave, in antisynch mode. Is that supposed to stay orange? I can cycle the modes/colors on the other driver through green, purple, yellow, and blue, but there is no corresponding change on the other driver (the orange one). Is this correct behavior (I assume it is but want to check). A mode is only set on the master, if I recall correctly, since slave follows master. Yes? No?
One driver shows orange LED. Per the manual, that indicates it's slave, in antisynch mode. Is that supposed to stay orange? I can cycle the modes/colors on the other driver through green, purple, yellow, and blue, but there is no corresponding change on the other driver (the orange one). Is this correct behavior (I assume it is but want to check). A mode is only set on the master, if I recall correctly, since slave follows master. Yes? No?
