Question About DC4's

[bigdee65]

I am in the market for a AC Jr for my new 75g setup and I had a question regarding the DC4's. I am going to need 2 of them for a total of 8 outlets, but I am going to be running them on a single circuit. Would this cause problems? I have yet to run the circuit but I think it will be 20A, not sure. After some ruff estimates it looks like my equipment will be under the 15A mark, so this should not cause any problems correct? Also, with the 2 DC4's, how would the AC Jr interact with both of them? Are there two ports in the AC for each DC4 or do I daisy chain the DC4's to the AC?

Thanks for any help you can provide.

 

[clp]

The AquaController connects to the DC4 through a telephone cord and RJ11 jacks. Each DC4 has two RJ11 jacks; one for communication in, and the other for communication out. So the telephone cord goes from the ACJR to the in port of the first DC4. The out port of the first DC4 goes to the in port of the second DC4.
Each DC4 can plug into a separate circuit. There are no requirements on phase/leg of power used. You can have two circuits or just one in your case.

Curt