gmneil
New member
ok i origionally drilled my look down tank for a 1" return from the bottom of the tank.
however i dont like the look of it where i am putting the tank
so i need to seal the 1" bulk head in the bottom and i am going to drill a return line from the side.
my 2 questions are
1. to seal the 1" retuen will a piece of glued pvc with a cap on it be sufficent.
2. and i have a 1-1/2 bulk head laying around if i use this and reduce it to a 1" pipe after the bulk head will noise become an issue,
this lookdown is one of those white pvc lookdowns 2' by 4' and 6" deep, and it is going to be set up to look decent in my living room
however i dont like the look of it where i am putting the tank
so i need to seal the 1" bulk head in the bottom and i am going to drill a return line from the side.
my 2 questions are
1. to seal the 1" retuen will a piece of glued pvc with a cap on it be sufficent.
2. and i have a 1-1/2 bulk head laying around if i use this and reduce it to a 1" pipe after the bulk head will noise become an issue,
this lookdown is one of those white pvc lookdowns 2' by 4' and 6" deep, and it is going to be set up to look decent in my living room
