Radion pro XR30 power supply mount for free if you need it

[mkart]

I picked up a 3d printer to play around with and printed this mount thinking it would probably fit my XR15 power supply, It didn't. Anyone want it they can have it for free. It is for a XR30 which has a larger supply than mine. I am printing all kinds of brackets and cable organizers to clean up my tank accessories. Amazing how well this thing works.

Sent from my iPad using Tapatalk

 

[Jboone82590]

Iv got the same one and I have been doing the same thing. They are great.

Sent from my SM-G892A using Tapatalk

 

[TanksDad13]

I picked up a 3d printer to play around with and printed this mount thinking it would probably fit my XR15 power supply, It didn't. Anyone want it they can have it for free. It is for a XR30 which has a larger supply than mine. I am printing all kinds of brackets and cable organizers to clean up my tank accessories. Amazing how well this thing works.

Sent from my iPad using Tapatalk

You're running too hot, that stringing in the corner pieces on the left is an indication. You can also play a bit with the retraction to reduce that. Looks cool though.


Sent from my iPhone using Tapatalk

 

[mkart]

You're running too hot, that stringing in the corner pieces on the left is an indication. You can also play a bit with the retraction to reduce that. Looks cool though.


Sent from my iPhone using Tapatalk

I thought it was because I selected support! Its PLA+ running at 210 degrees. It's happened on another print as well. I'll try turning it down.

 

[TanksDad13]

I thought it was because I selected support! Its PLA+ running at 210 degrees. It's happened on another print as well. I'll try turning it down.

Supports typically run vertically. The "œTree like" supports have "œbranches" but even those are at an angle, not horizontally.

Sent from my iPhone using Tapatalk