Hello,
I have the parts to upgrade my RS6-2+ to a RC skimmer however, I ran into a little dilema tonight. I intended on using the stock hole for my input and drill below it for my new intake....well it turns out the length of the venturri and a 1" elbow is way too long. My new idea is to plug the original hole and drill a new hole about 1" above it which will make room for the intake. Is this the best way to approach this?
Thanks,
Greg
I have the parts to upgrade my RS6-2+ to a RC skimmer however, I ran into a little dilema tonight. I intended on using the stock hole for my input and drill below it for my new intake....well it turns out the length of the venturri and a 1" elbow is way too long. My new idea is to plug the original hole and drill a new hole about 1" above it which will make room for the intake. Is this the best way to approach this?
Thanks,
Greg
