redtop's Ferduino controller
- Thread starter redtop03
- Start date
as of right now when I try to put in a password it puts the asterisks across the bottom line of the 6 and 7 box's cancel button does not work no matter where you touch any where around it. I have to go to Home screen then back to passcode page to re-enter it each time 01 28 67 and 123456 do not work going to re-calibrate again 3rd time 
fefegarcia1
Member
3rd time didn't help. And there is no pass code set just click on enter to get in Willie can I trouble you to zip up all your files and send them to me ???
have all the modification's threw these pages been done to the version that is on github for Feduino_with_webcontrol_beta7_0???
have all the modification's threw these pages been done to the version that is on github for Feduino_with_webcontrol_beta7_0???
marspeed
Member
Ok so I just checked most of the buttons and only a few are slightly off but they still work if I tap a hair off center I am sure this is a calibration issue and not a big deal for now as for just hitting enter at the password screen thats perfect I would go mad having to enter a password all the time
I seen the code to bypass the password screen on Fernandos site does that mean it won't show up or will it be as it is now where you just hit enter ?
I seen the code to bypass the password screen on Fernandos site does that mean it won't show up or will it be as it is now where you just hit enter ?
marspeed
Member
The reason I ask is because the w5100 uses the icsp header wich means it needs to be on top the mega if you break continuity with pins 10 11 12 13 and they are used by the sketch then I lose thoes pins on my screw sheild now I understand I can jumper them to the screw sheild but thats not very neet and begins to defeat the reason for the screw sheild
fefegarcia1
Member
On Arduino mega are the pins 50, 51, 52 and 53.
Check it: http://www.ferduino.com/forum/viewtopic.php?f=24&t=36
marc it does not have to be connected to the icsp header on the mega if you look at the other boards Fernando has recommended they do not have icsp headers. I am using the little one I will have jumper wires going back to the arduino so I do not have to have a tall stack just trying to make it easier to mount in a case
fefegarcia1
Member
Hi!
root the ICSP header is on bottom side.
Best regards
Fernando Garcia
root the ICSP header is on bottom side.
Best regards
Fernando Garcia
I tried to calibrate the screen 2 more times then used the test tool and failed each time so I used the recommended settings and now it is working better I have no bars for leds but I think that is because I have do not have a clock on it yet I will later today and temp probes
