bidny
Member
When I attempted to set up my ReefLink via my Mac (OS X 10.9.3), the ReefLink Setup utility asked me to upgrade to version 1.0.6, which I did.
Afterward, the setup utility failed to recognize my ReefLink, stating:
"Please connect your ReefLink with a USB cable."
I tried multiple USB ports with no luck.
I then uninstalled the utility and installed it again without the 1.0.6 upgrade.
Version 1.0.3 seemed to recognize my ReefLink immediately, but it's been stuck on the following screen for a long time"
"Please wait a moment while your ReefLink initializes..."
I specifically waited to purchase my Radions and ReefLink in order for EcoTech to work out these issues, as I had heard quite a bit about problems with the product.
As the happy owner of multiple Vortech pumps, I decided finally to take the chance. Unfortunately, the first thing I ran into was this issue, which is quite disappointing.
I hope this is just a small hiccup, and that once I'm up and running, it'll be smoother sailing.
Afterward, the setup utility failed to recognize my ReefLink, stating:
"Please connect your ReefLink with a USB cable."
I tried multiple USB ports with no luck.
I then uninstalled the utility and installed it again without the 1.0.6 upgrade.
Version 1.0.3 seemed to recognize my ReefLink immediately, but it's been stuck on the following screen for a long time"
"Please wait a moment while your ReefLink initializes..."
I specifically waited to purchase my Radions and ReefLink in order for EcoTech to work out these issues, as I had heard quite a bit about problems with the product.
As the happy owner of multiple Vortech pumps, I decided finally to take the chance. Unfortunately, the first thing I ran into was this issue, which is quite disappointing.
I hope this is just a small hiccup, and that once I'm up and running, it'll be smoother sailing.