Remote Control/Monitor of PH

[layer3switchguy]

Folks,

I'm still trying to come up to speed on the Profilux products and had a quick question. I want to be able to control/monitor my CA reactor of adding Co2 at a set PH value. My reactor is in the basement with my sump, and the main display tank is on the 1st floor. It's a distance of perhaps 20-30 feet or so, directly below the main tank.

How could I go about doing this with the Profilux, and would any of the models work?

Also, is there a chart that shows the features/functionality between the Plus II, Plus II EX and the III, and III EX?

Thanks!
L3

 

[MSHUR]

I use P2 to control Co2 level on my CARX, very easy to set it up..Where do you plan to keep Profilux near the tank or by the sump?

 

[GoToSleep]

Any of the models from Plus II through 3EX should be able to control your reactor for you. You may well want to purchase an add on pH card and a second pH probe. These combined with the standard pH connection and probe will allow you to monitor pH of your reactor/efflluent and also monitor pH in the tank or sump. I have seen a nice comparicon table of the various models somewhere (I think perhaps within this subforum but I can't put my cursor on it at the moment).

 

[GoToSleep]

Also, is there a chart that shows the features/functionality between the Plus II, Plus II EX and the III, and III EX?

Thanks!
L3

I knew that it was here somewhere.

http://www.reefcentral.com/forums/showthread.php?t=1766151