Resetting Vectra M1

[oseymour]

I calibrated the Vectra M1 with the driver that set the high point and low point. I would now like to reset the driver and remove the settings. How do I do that? Can someone point me to some instructions?

Thanks

 

[Alex Y EcoTech]

You will need to perform a hard reset on your controller. To do this, please follow the steps below:

1) With the controller powered on, press and hold the "Mode" and Set" buttons until the dial blinks Red, White and Blue.
2) Press and hold the "Mode" button until dial blinks Red and Purple.
3) Press and Hold the "Mode" and "Power/Option" buttons until the pump powers off and resets.

 

[oseymour]

You will need to perform a hard reset on your controller. To do this, please follow the steps below:

1) With the controller powered on, press and hold the "Mode" and Set" buttons until the dial blinks Red, White and Blue.
2) Press and hold the "Mode" button until dial blinks Red and Purple.
3) Press and Hold the "Mode" and "Power/Option" buttons until the pump powers off and resets.

Thanks that worked perfectly.