RODI system.. how to mount to wall?

[125mph]

Which screws do you guys use to mount your RODI system to wall? Any screw will do? Just make sure it goes to stud?

 

[ericarenee]

My Basement walls are Concrete I Used Lead anchors to attach a piece of 3/4 ply onto the wall then mounted the unit on the plywood with Tech screws

 

[Blitz132]

I use a piece of stained router edged hardwood. Attach it to the wall with long screws into the studs. Then I mounted the RO/DI system onto the hardwood.

 

[125mph]

Is it just two screws that holds the RO bracket to the hardwood? Same with the DI bracket, just 2 screws?


Sent from my iPhone using Tapatalk

 

[Blitz132]

Yeppers... with the brs, the bracket is slotted so you can remove the units..

Sent from my SM-N915V using Tapatalk

 

[125mph]

Awesome! Just got some oak boards and nice thick wood screws will install tomorrow.


Sent from my iPhone using Tapatalk

 

[becon776]

Lag bolts on to wood (need stud) or tap cons into concrete (predrilled)

Sent from my SM-G935T using Tapatalk

 

[homer1475]

Sheetrock screws into the studs. Been that way for well over 3 years.

Lag bolts? Isn't that slightly overkill? It's not like the things weighs in excess of 10 pounds. You could probably get away with hollow wall anchors if there are no studs around.

 

[Vinny Kreyling]

I would not trust wall anchors because--
When the housings have to be removed for filter changes they can be a bear to get off.
Use the board anchored into studs.

 

[Blitz132]

Here is a picture of my setup after I mounted everything..

 

[125mph]

Okay, I'm all set up.

Sent from my iPhone using Tapatalk