Ok i started to make some water. I have the BRS 4 stage RODI with dual inline TDS. I have attached a aquatec 8800 booster pump where i'm getting around 90psi. Firstly the red tubing going into the first chamber is leaking., not crazy but it is definetly coming out. I tried pulling it out and putting it back in no luck. Hoping i'm not going to have to send this back. Is there any other remedies? Secondly the DI portion of the RODI is definetly getting water but it seems like you can only see it about 1 inch from the bottom. Is that normal. It is producing water. The IN is .001 the OUT is 0
RODI Water
- Thread starter fernalfer
- Start date
TangingOut
New member
Remove it and give it a fresh clean cut and re-insert, pushing in hard and all the way. HTH
Cut it three times. Each time pushing it tight itno the fitting and giving a little snug. NO GO still leaks.
TangingOut
New member
Also, is 90 psi within it's operating range? Seems kinda high.
Thought about that but still leaks when i take the booster pump off and it runs at 38psi
BrokenSpoke
New member
Sounds like you may have a bad fitting. I'd give BRS a call on Monday and I'm sure they will take care of you. You might also try a LFS and see if they might have a fitting you could replace it with.
crocogator106
New member
I had the same issue only mine was leaking in 3 different places. I contacted BRS and they sent instructions on possible remedies. None worked so I had to send it back and they sent me an email that they fixed the leak issues. Tracking number says it should be delivered Monday. I sure hope its fixed because I'm waiting on it to start cycling 50lbs of rock! They did pay for the return shipping though.
Similar threads
