Salifert Nitrate Test

Icewing726

New member
I got this after being shown how to use it in a LFS. For low range I was told to look through the side, for high range I was told to look through the top. My question is do I look at the color in the center or edges when looking top down? Am I supposed to pool it to one side first?

I tried watching videos on this but all the "instructional" videos showed was perfect water being tested... Not sure how you can review a test kit that may not work at all with perfect water (clear result)...

Anyway any knowledge someone can share would be appreciated.
 
if youre looking from top down just look at the center. You shouldn't have to pool it to a side if you're looking top down. The color should be the same in the center as it is on the edges.

You're supposed to put it on the white part of the colormatching paper, and look down onto it in a well lit room.

If you can't tell the color difference well by looking top down, it means you need to look from the side (the low range)
 
if youre looking from top down just look at the center. You shouldn't have to pool it to a side if you're looking top down. The color should be the same in the center as it is on the edges.

You're supposed to put it on the white part of the colormatching paper, and look down onto it in a well lit room.

If you can't tell the color difference well by looking top down, it means you need to look from the side (the low range)

When I look top down the edges (right next to the cup) get darker then the majority of the center. Most likely due to the light diffusing right there.

I've been going by whats in the majority of the center, but I saw someone show the camera his test and he tilted the cup to where it pooled on one side (didn't think that was correct).
 
Make it easy.. If its any bit pink you have work to do ;)
If you are like "is that clear or is there a slight tinge of pink.. I can barely tell" then your work is done
 
Save yourself some headache(hate the salifert nitrate test), and get the red sea pro nitrate kit. Color changes are way easier to see, and they give you 2 bottles, and a color wheel to compare to. One bottle you put plain water in, second bottle you do your test in. Let sit for 9 minutes then rotate the wheel to match colors between the 2 bottles.
 
For Ammonia, Nitrite and Nitrate just use the API test kits. They give you clear results that are easy to determine. Especially for your initial cycle. And are readily available at your local pet store. Honestly, the Salifert test kits for these three are horrible to read.
 
Even more honestly, you could save money on kits in the long-term: your tank will tell you if there's too much nitrate by way of pest algae and bursts of other life that comes from overfeeding/poor nutrient control. Seriously, after your first year or two, you'll wonder at how often you used to perform tests. It gets better.
 
I hope the nyos kit is more accurate because its been showing lower levels of nitrate from running biopellets than salifert. Might try red sea after.
 
Back
Top