Setting Temp Offset

[mozz]

Hi, I just added the PM2 unit with Cond and Temp probes. I placed both temp probes next to one another in the tank and there is a difference of 1.3 degees. I want to reduce the new temp probe because everything else is dependent on the first probe's reading. The problem is, its not showing up on the apex display. The temp2 reading displays, but on the setup menu only the first temp probe shows. I ran the firmware update on the display but it didn't help. The cond probe shows up in the setup menu. Thanks in advance for any help you could give.

 

[Orcrone]

On the web interface is it enabled through the Configuration - Probe Setup menu?

 

[mozz]

Its greyed out on my web interface. I'm running 4.05_4B11.

 

[peiloy3196]

I had the same issue and I just calibrated the PM2's Temperature Probe to the Value on the base temperature probe.

 

[mozz]

Thanks for the help, I got it.