setting up for flash stick

[jwalters103]

can anyone tell me how to do this? i got it yesterday and dont really have time right now to play around with it and try to figure it out. i plan on connecting it to the l3/l4 socket.

also, what will i have to do to add a second one? just add a splitter? any changes to the software settings for that?

 

[AQD_ottawa]

The best way to learn is to play around with it

Have a go when you get a few minutes and then drop back if you get stuck, its all explained in the illumination settings and 1-10V set up

 

[jwalters103]

the manual says that "when using our dimmable moonlight led's the voltage should be set at 0.8v". is this maximum or minimum? does this hold true for the simu stick? should it really be 0.8 or should it be 8?

 

[AQD_ottawa]

mimimum

 

[jwalters103]

can i set the minimum to 0.8v if the outlet covers 1-10 v?


what do i set the maximum for?


i sat down with this thing and the manual for a couple hours last night, and im lost.

im trying to set it up on l3/l4 with 3 being moon and 4 being sun.

that much i have figured out, but that is where i get lost

 

[jwalters103]

ok currently i have it set to 0.8v minimum and 10 v max.

now, how do i get the thing to turn on?

how do i program a timer for it?

 

[AQD_ottawa]

set L3 under 1-10V interface to illumination 1

Set L4 under 1-10V interface to illumination 2

Go to illumination 1 and set to dimmable then set you ramp up and down times then do the same to Illumination 2 for the other colour

 

[jwalters103]

ok, i did that, but the red lights didnt come on. ill have to wait another hour and a half to see if the moonlights come on

 

[AQD_ottawa]

or use the simulation screen and move the slider along.