Streetmagus
New member
I had my DT tank running fine for a few months. Added a Coral Banded Shrimp, and made the mistake of not quarantining him. Well, per LFS advice, I should just dump him in the tank.. I had concerns with their water and he said the tanks the inverts were in are free of meds, water was good and should be fine. He said I shouldn't net him, since that might cause him to lose his claws. So he recommended I just acclimate and dump him straight from the bag. My mistake..
Fast forward 2 weeks later, regal tang(1.25inch) showed a few spots. I've delt with freshwater ich, so I was familiar with what they might look like. Those 3 spots went away. About a week later, showed a lot more ich spots, the flame angel (1 inch) also developed a few on his tail. I also have 2 clownfish(1-1.5inch) and a benggai cardinalfish (1 inch) which are not showing any visible ich.
Did a lot of research, apparently marine ich is a lot more of a nuisance than freshwater ich, also harder to treat...went back to LFS to buy heaters for QTs. I've just spent 2 hours carefully remodeling the rockwork in order to net all the fish out. They're all in 20gallon QTs. Each fish is in their own QT, except for the pair of clowns. Per LFS advice, and a lot of online sources, they recommended hyposalinity as the safest and best way to approach this..
But I'm not sure what to do at this point. Right now, all the QTs SG are at 1.025, using a refractometer that I calibrated with RO/DI. I understand I need to be at 1.009 in order to kill the ich?
A couple of questions: I've read different forum posts regarding lowering the salinity, some say lower it in 48 hours, some say 3-4 days. What are your experiences in lowering SG? What's best? Currently I have the tanks half filled...I plan to slowly add RO/DI water over the next few days to lower salinity. Is this a safe approach?
Also, the tanks are bare. Only thing in them at the moment are heaters and a thermometer. Do I need a mechanical filter? I've read the article where they recommended a filter and replacing the filter everyday. What's the purpose of the mechanical filtration, since the DT doesn't require it?
Also, one employee recommended copper or Kordon's Rid-Ich (supposedly treats marine ich as well). I've never dealt with copper, but had success with Rid-Ich on freshwater ich. Would anyone advise against these products, if so, why?
Thanks in advance for your advice.
Fast forward 2 weeks later, regal tang(1.25inch) showed a few spots. I've delt with freshwater ich, so I was familiar with what they might look like. Those 3 spots went away. About a week later, showed a lot more ich spots, the flame angel (1 inch) also developed a few on his tail. I also have 2 clownfish(1-1.5inch) and a benggai cardinalfish (1 inch) which are not showing any visible ich.
Did a lot of research, apparently marine ich is a lot more of a nuisance than freshwater ich, also harder to treat...went back to LFS to buy heaters for QTs. I've just spent 2 hours carefully remodeling the rockwork in order to net all the fish out. They're all in 20gallon QTs. Each fish is in their own QT, except for the pair of clowns. Per LFS advice, and a lot of online sources, they recommended hyposalinity as the safest and best way to approach this..
But I'm not sure what to do at this point. Right now, all the QTs SG are at 1.025, using a refractometer that I calibrated with RO/DI. I understand I need to be at 1.009 in order to kill the ich?
A couple of questions: I've read different forum posts regarding lowering the salinity, some say lower it in 48 hours, some say 3-4 days. What are your experiences in lowering SG? What's best? Currently I have the tanks half filled...I plan to slowly add RO/DI water over the next few days to lower salinity. Is this a safe approach?
Also, the tanks are bare. Only thing in them at the moment are heaters and a thermometer. Do I need a mechanical filter? I've read the article where they recommended a filter and replacing the filter everyday. What's the purpose of the mechanical filtration, since the DT doesn't require it?
Also, one employee recommended copper or Kordon's Rid-Ich (supposedly treats marine ich as well). I've never dealt with copper, but had success with Rid-Ich on freshwater ich. Would anyone advise against these products, if so, why?
Thanks in advance for your advice.