Stream placement and settings

[stros]

Richard,
I would like to know what is your recomendation for setting on my 2 6000's. My tank is 24x24x48" 120gal. It is a room divider tank that can be seen from 3 sides. The overflow is on one end and i have both the streams mounted along side the overflow. They are hooked up to port8 and 11 on the controller. I would like to have them alternate the flow. Could you please tell me what each of the dials and switches should be set to? Also can they be slowed down by turning the screw in the driver unit? I seem to have a little too much flow.for some of my corals. Any help would be appreciated.

Mark

 

[rvitko]

It s either or on the power setting. If you have a controller the driver has to be at 100% with no controller you use the driver. I would use tide mode- two arrows pointing at each other. Then you set the interval, the first is the switch which selects the range and then the knob which sets the interval within the selected range. The pump that is on will pulse so you set the pulse interval and your two power settings for each pump, keep in mind the bottom setting is what is used in night mode.