Cove Beach
New member
I posted a little while back about finding an algae clip that my sailfin couldn't yank the algae out of. I got a couple suggestions but none really appealed to me. So i came up with this from stuff i had laying around. Its pretty simple to make, the only change i will make is to change the nylon nut to a wingnut. Basically all i did was to take a 2" section of 1" PVC pipe, drill a 1/4" hole through it. Then slice it on my bandsaw and then bevel the cut edges slightly to form gripping jaws. To lessen the tension on the bolt i relief cut the back side of the PVC with my bandsaw. I then put the 1/4-20 nylon bolt through an acrylic hanger(had it from the old one that didn't work), then through the hole in the PVC . I then threaded on a nylon nut. (change to a wing nut to make it easier to load). Here is the completed algae holder.