victornator333
New member
Ive been running a 6x39w Tek Elite fixture for about 6 months now.
The fixture has three holes on the top of each end of the fixture.
The hanging kit I received with the fixture has two pieces, that I assumed went into the outside two of the three holes on each side.
However, one of the holes on the fixture was "stripped" so I had to use the middle and an outer hole on one end of the fixture.
It was offset but i solved the issue by offsetting how I hung the fixture.
This was working fine until i took the fixture down for cleaning today and the hanging piece popped out of the other outside hole on the left, leaving me with only a single "unstripped" middle hole from which to attach the fixture on the left.
It is currently hanging from one point on the left and two on the right!
What should I do??
here is a picture if it helps explain it a little better
(its a little blurry but the attached hole pictured is the middle one)
Thanks!
The fixture has three holes on the top of each end of the fixture.
The hanging kit I received with the fixture has two pieces, that I assumed went into the outside two of the three holes on each side.
However, one of the holes on the fixture was "stripped" so I had to use the middle and an outer hole on one end of the fixture.
It was offset but i solved the issue by offsetting how I hung the fixture.
This was working fine until i took the fixture down for cleaning today and the hanging piece popped out of the other outside hole on the left, leaving me with only a single "unstripped" middle hole from which to attach the fixture on the left.
It is currently hanging from one point on the left and two on the right!
What should I do??
here is a picture if it helps explain it a little better
(its a little blurry but the attached hole pictured is the middle one)
Thanks!
