The perfect model for a 125g SPS tank.

[Ralphyhp]

I just want to know if this model works good on my 72" long AGA 125g tank:
http://www.marinedepot.com/md_viewItem.asp?idproduct=TZ1317
I have a 1" SeaSwirl plug on a 40rltx Iwaki pump. My tank is a SPS dominated tank so i need good water movements. Any advice would be perfect. Thanks in advance, Ralphy.

 

[Ralphyhp]

By the way, do anybody knows where to fine the best price on the Tunze Turbell stream models.

 

[rvitko]

The Streams are out of stock everywhere now so it is unlikely they will be available below MSRP which is what Marine Depot is offering them for. A 6100 is a lot for a 125, it can work but it may be a problem if you have fine sand and not alot of rock. If you have course sand or no sand and 120+ pounds of rock it should be OK.

 

[Ralphyhp]

Thanks for the info. rvitko if the 6100 are to much wich model can fix on my tank. I have a 3" DSB plus 300lb of LR and the SeaSwirl use to stir the sand. What about this: http://www.marinedepot.com/md_viewItem.asp?idproduct=TZ1311 or this :http://www.marinedepot.com/md_viewItem.asp?idproduct=TZ1315 , Thanks again, Ralphy.

 

[rvitko]

The 6080 cannot be controlled or used on a wavemaker. Ideally I would use 2 6000's and a Multicontroller. You have a Seaswirl which is great so you could use the 6080 and rely on the Seaswirl to make the current more random or you could start with one 6000 and add a second later.

 

[Ralphyhp]

Thanks Roger, I decided for the Two 6000 on a multicontroller setup. Did the multicontroller have everything to run the two 6000 pumps or i need to buy anything else. Another question is, wich holder extension i need for a AGA 125g tank the TZ1531 or the TZ1533. Thanks in advance, Ralphy.

 

[rvitko]

Our part number for the holder extension is 3000.244. I don't know which vendor part number. The multicontroller comes complete.