Can't find any mention if this and it's getting to me. Instructions to connect vortech to reeflink says hold the 2 buttons until it flashes red n white. Mine flashes red white and blue. Then hold set until it flashes blue and green, mine won't do that unless I just press set once. And I've tried a few tones it just blinks blue n green for 15+ minutes before I give up
Trouble updating mp10 and reeflink
- Thread starter Skuba
- Start date
Alex Y EcoTech
RC Sponsor
Skuba,
You will need to have the Mode and Set buttons depressed before applying power. After power is applied continue to hold Mode and Set until the drive flashes red and white.
You will need to have the Mode and Set buttons depressed before applying power. After power is applied continue to hold Mode and Set until the drive flashes red and white.
That's exactly what I tried many times. But it would only goto red white and blue
Honestly this vortech integration was the deciding factor for me to go radion instead of upgrading my sol to hydra 52 or building a diy. If I can't get this to integrate soon ill be reverting back. I understand any new system had a learning curve, but I don't think my corals understand that.
Alex Y EcoTech
RC Sponsor
Skuba,
Is this an MP10wES? You will need a wireless EcoSmart controller in order to program your VorTech via ESL.
Is this an MP10wES? You will need a wireless EcoSmart controller in order to program your VorTech via ESL.
Yes it is. My driver box says mp10 W. but I purchased a w-Es and it has the nutrient export mode and all so it should be the correct model
