Trouble with tunze 5017

[water is wet]

I have two that have been on a shelf for about two years and now I can't get either of them to stay powered on. I can get one of them to work if I hold the part of the power supply that plugs into the controller at just the right position and the other worked for a couple of days once I found that sweet spot but no longer does so. I don't see any corrosion or anything odd I even took the back off of one of them and everything appeared fine.

 

[rvitko]

Check the inner positive contact on the power supplies, this tends to corrode quickly if they get wet while plugged in and is the most common cause, if so, a new power supply is what you need.

 

[water is wet]

I took a look at them and one of the power supplies looks like it may have a bit of corrosion but the other does not appear to and the controller does the same thing regardless of the power supply being used. Do you have an email address that I could send a short video to so you can see what's happening? I don't really want to order a power supply if I actually need a new controller.

Thanks

 

[rvitko]

The most useful would be clear photos of the plug ends, if that inner tip is not shiny nickel plate, this is surely a culprit, it is possible the female end is corroded and without knowing the age I don't know which version of socket you have, but they can generally be cleaned and adjusted and a replacement controller is not likely needed unless they are very old units.

Tunze at sbcglobal dot net

 

[water is wet]

It would seem that sliding the board down as you suggested did the trick although for some reason I did have to trim a little around the opening to keep it from happening after it was all put back together. You Rock!

Thanks!!!

 

[rvitko]

Great news, thank you!