Trying to figure out the best way to cable my waveboxes and streams

[fletchman]

I was trying to figure out what the best way to cable my wavebox and extension, and my controller, and 2 6100 streams... I got the y adapter boxes dropshipped to me last night..and attempted to wire them up.. I was thinking, or should i say attempting to run the streams in tidal mode... as per the instructions.. but it didnt seem that the y adapter, or boxes worked correctly... I am guessing i am screwing it up.. but if anyone has done this.. or if i can get some help figuring out how to cable them up... the single wavebox is no issue to make this work... but the slave box throws me for a loop

thanks,
:eek1:

 

[rvitko]

I will call you this afternoon. Basically the master cable should be connected to the branch adapter, the two waveboxes should be connected to the respective side of the branch adapter. The wave controller 6091 should be set to extern. The slave cable is then connected to the multicontroller. The 2 6100's are also connected to the multicontroller.

 

[fletchman]

was also wondering what the best placement for the streams would be.. i was planning on putting them on the opposite side of the 400 gallon tank.... so waveboxes on one side...and then the streams on the other... if this is not the best way.. i could most likly get them on the same side as the waveboxes it would just be tight.. but possible... really looking forward to getting it all running at one time.... awsome products... not a complaint short of the bracket mount kits for the streams.. but the magnents.. take care of that nicely...I appreciate the time... looking forward to the call

Ryan