tunze 6055 with 7095

[Alexandre13]

Hello,

I have 2 tunze 6055 conected to 7095 and i put the contrlle on the max. speed and the leds only go`s to 80%, you know why the 7095 controller don`t go at 100%?

Thanks

 

[rvitko]

By feel, compare the flow with no controller and full power on the pump and 100% setting on the controller, they should be the same. On the smallest pump models due to low amperage available it was possible that the 7095 is at 100% but only shows 80%. Also, if this is an older 6055 with the power supply with voltage jumpers, it should have the 24V jumper installed. This will typically be only that their is not enough power to light the 100% light, but it is at 100%.