TUnze Pump flow percentage range...

[cagri]

I just would like to confirm that it is ok to set the flow rate from let's say %10 to %100 if I set the volts from 3v-8v.

Roger from tunze said that one is not supposed to set the pumps less than %30, or damage can occur. So if I set it at %10 is that going to cause damage or is setting it at 3v already puts the pump at %30 so the baseline starts at %30???

Thank You

Cagri

 

[Matthias Gross]

either you set the voltage range to 0V...10V and the percentage to 30% to 80%

or

3V to 8V and 1% to 100%

-> has the same results