Tunze Wave Action

[hollback]

I am using my Apex to make a wave but there is a delay between pumps. If I watch the lights on the base unit I can see a delay. Here is what I see.

Pump 1 Light ON > Pump 1 Light OFF > Pump 2 Light ON > Pump 2 Light OFF > Delay > Pump 1 Light ON > Pump 1 Light OFF > Pump 2 Light ON > Pump 2 Light OFF > Delay >...

On my AC3 there was no delay when the cycle started over and now on the Apex there is and it's interfering with my wave effect. Here is my profile code:

Wave_Lt
Synchronize Disabled
Divide by 10 Enabled
Initial off time 0
On time 6
Off time 8
Minimum intensity 0
Maximum intensity 100

Wave_Rt
Synchronize Enabled
Divide by 10 Enabled
Initial off time 8
On time 6
Off time 0
Minimum intensity 0
Maximum intensity 100

Running version: 4.05_4A11

 

[hollback]

Am I the only one who has had this happened?

 

[hollback]

Issue resolved. Thanks Curt!!!

 

[swearint]

What was the solution? I don't currently use my Tunzes for a wave, but might in the future.

Todd

 

[hollback]

Curt provided the following code which created the pause between pumps instead of a longer pause as the cycle started over. If you graph it in Excel you can see the .1 second pause between pumps.

Wave_Lt
Synchronize Disabled
Divide by 10 Enabled
Initial off time 0
On time 6
Off time 8
Minimum intensity 0
Maximum intensity 100

Wave_Rt
Synchronize Enabled
Divide by 10 Enabled
Initial off time 7
On time 6
Off time 1
Minimum intensity 0
Maximum intensity 100

For some reason, having the pause in there creates a really nice wave for me. Having the same number for both the on and off state doesn't work in my display. Strange isn't it?!