Tunze wavebox and 7095 controller

[NeuroLarry]

I have a tunze wavebox, 2 6100 pumps and a 7095 controller can you give me some specific settings to generate a wave? I need specifics for each option, ie sequential, interval, pulse power settings and timing settings at least to start. I am apparently rather simple minded and don't have a good idea of the general concept from the owners manual. Thanks

 

[rvitko]

The wavebox would require the 6091 controller and you would use that to tune an actual wave. I would do that first and then connect the 6100's to the 7095 and use the 6100's to produce directional tidal currents. Set a pulse of 3 seconds. Select Interval 2 mode with a 6hr interval. Place a pump in each back corner and aim them to hit the front about 2/3rds of the length down the tank. Set your speed knobs at 30% and 1005 on each channel and this should give a tidal flow while the wavebox creates the actual wave independently.

 

[NeuroLarry]

Perfect Thank You!!

 

[NeuroLarry]

One more thing where do I get to 6091 controller they only seem to be available with the wavebox.

 

[rvitko]

You can order it as a spare part on tunze.com or from any of our dealers.

 

[NeuroLarry]

Thanks I ordered one from marinedepot

 

[MAXreefer]

I have al most the same setup as you. Wave box and 2 x 6101.
I followed Roger's setup suggestion as described above and I love it.
You will be happy

 

[NeuroLarry]

I have and I am. I think they need to put a section in the owners manual that spells it out in 3 lines for people like me.