broadwave
New member
Got an alert this morning that my Vectra M1 (return pump) was not communicating with ReefLink. I immediately went into my filter room and noticed that the return pump was not pumping water and that the Wireless Indicator was white with an occasional red blink. Tried resetting, removing and re-adding to reeflink...nothing...
Since my skimmer is also using an M1, I switched the controller boxes to see if it was the pump or the control module. Sure enough, the return pump started to work now being connected to the the good control module.
Figured I could go Thanksgiving dinner with the skimmer off-line for a few hours and deal with it when I got back home.
Well... this time I was able to factory reset the "bad" control module and add to my ReefLink set up, all good... (lights Green and wireless indicator is Blue) BUT... the pump is not pumping ANY water!?!?!? So, just to be sure I switched the controllers again and sure enough it is definitely not the pump.
Has anyone ever run into this before and if so how do you get the pump to pump water again?
Since my skimmer is also using an M1, I switched the controller boxes to see if it was the pump or the control module. Sure enough, the return pump started to work now being connected to the the good control module.
Figured I could go Thanksgiving dinner with the skimmer off-line for a few hours and deal with it when I got back home.
Well... this time I was able to factory reset the "bad" control module and add to my ReefLink set up, all good... (lights Green and wireless indicator is Blue) BUT... the pump is not pumping ANY water!?!?!? So, just to be sure I switched the controllers again and sure enough it is definitely not the pump.
Has anyone ever run into this before and if so how do you get the pump to pump water again?
