Hi guyââ"šÂ¬Ã¢"žÂ¢s
I have notice that my gauge stay on little bit longer then I usually see it (the gauge on the membrane). Therefore, I decided to check the flow ratio. I set up a gallon jug for the pure water. I put the wasted water drain into a six Ã"šÃ‚½-gallon bucket (Instant Ocean bucket). When the gallon jug got fill, I shut the valve that goes to my safety float for my aquarium sump. I go check the waste bucket and I see it still drain, I know it suppose to do that for a very short time. I have done this to make sure that when I replace my new membrane the ratio is should be 4 to 1. Have it for about 5 to 7 years. Therefore, I decided to come back later (lunch
). I came back, it was still draining into the bucket that is full, and so I switch to another bucket. It was weird so I decided to shut the supply off. Turn the supply on and the gauge is readied no psi. Therefore, I try again but this time I just fill a 2 cup of water but the wastewater was about two gallon waste in the bucket. Therefore, I did it again to shut the supply then turn back on and no psi. So my ratio is 6-gallon plus to 1-gallon. Help
City water that come in is 55-psi., it a 90-gallon per day unit, with DI. The water tempter is 45 degree.
Any suggestion please let me know, thank you
I have notice that my gauge stay on little bit longer then I usually see it (the gauge on the membrane). Therefore, I decided to check the flow ratio. I set up a gallon jug for the pure water. I put the wasted water drain into a six Ã"šÃ‚½-gallon bucket (Instant Ocean bucket). When the gallon jug got fill, I shut the valve that goes to my safety float for my aquarium sump. I go check the waste bucket and I see it still drain, I know it suppose to do that for a very short time. I have done this to make sure that when I replace my new membrane the ratio is should be 4 to 1. Have it for about 5 to 7 years. Therefore, I decided to come back later (lunch
). I came back, it was still draining into the bucket that is full, and so I switch to another bucket. It was weird so I decided to shut the supply off. Turn the supply on and the gauge is readied no psi. Therefore, I try again but this time I just fill a 2 cup of water but the wastewater was about two gallon waste in the bucket. Therefore, I did it again to shut the supply then turn back on and no psi. So my ratio is 6-gallon plus to 1-gallon. Help City water that come in is 55-psi., it a 90-gallon per day unit, with DI. The water tempter is 45 degree.
Any suggestion please let me know, thank you
