Water on 6105 Connection

[PhilipOSU]

My wiring for my 6105 fell and in the same time frame an o-ring on a return line check valve has failed and obviously the drip was right above the fallen 6105 connection between the pump and power supply. I am drying it out not, but was curious what I should be expecting that I will need to repair or replace... Any feedback would be appreciated.

Thanks,
Phil

 

[rvitko]

Usually if the power was connected, the pump needs a new end connector and a new power supply.

 

[PhilipOSU]

Thanks Roger. I didn't see the end connector on the Tunze parts section of the website. Where can I get this from?

Thanks,
Phil

 

[rvitko]

It would have to be sent in for this part to be replaced, 5 wires have to be unsoldered and resoldered to the new connections.