Wiring a Ballast..at a loss??

[Bill0814]

I am trying to wire a Fulham Workhorse 5 Balast to a 96w PC Flourescent? Pin Connection.

Ballast has 4 Red wires and 1 Yellow.

Diagram shows 1 Yellow goes to One set of connectors and 3 red go to other.

I get nothing.

if I just use 1 red it fires one tube?

Any ideas?

 

[RobinsonFam1]

go to fulham's web site. i have had to refer to it many times but have since lost the link. if youre not careful you can ruin both the ballast and the bulb.

 

[boss252]

Did you jumper the yellow wire to all the sockets?

 

[theevoys]

I just wired a fulham lonhorse 5 which is the same wiring as the workhouse. I clipped off 1 of the red wires completely. Then, you split (sorry I dont know electrician language) the one yellow wire to the two different bulbs and then take each left over red wire to the two different bulbs. Of course, it has to have enough power to fire the two bulbs. That should get them to work Good luck!

Just in case here's the diagram from Fulham

http://www.fulham.com/wiringdiagrams.php

It is Wiring Diagram #5