scar79
Member
I just got some Radions and a WXM module and I've run into a roadblock quite early in the setup process. My base unit's firmware is current (4.32_7A14), and I've updated the WXM's firmware to 010, at which point the Module Status Box reads Rev 0.0, RF Rev 0.0 (1,0,0,0),(0,0,0),(250,0,0). That 250 figure climbs from 0 after the firmware update but always stops at 250. After I select the RF Update radial and click WXM Firmware Update, three lines are added below:
Update Status: 0
Update State: 7
Update Error: 0
I've tried this many times with the same result. Sometimes, I even lose all of the modules in the drop down box and have to cycle power to my base unit to get them to return. The display reads WXM Update and only gives option to Exit.
One other thing to note is that the wireless status light on the module never lights up (but the status light is green).
I have tried cycling power to the unit, disconnecting and reconnecting the WXM to the aquabus, and deleting and reinstalling the module.
Help is appreciated!
Update Status: 0
Update State: 7
Update Error: 0
I've tried this many times with the same result. Sometimes, I even lose all of the modules in the drop down box and have to cycle power to my base unit to get them to return. The display reads WXM Update and only gives option to Exit.
One other thing to note is that the wireless status light on the module never lights up (but the status light is green).
I have tried cycling power to the unit, disconnecting and reconnecting the WXM to the aquabus, and deleting and reinstalling the module.
Help is appreciated!
