WXM sync problem

[MAXreefer]

I have an issue getting to run 2 Vortech pumps in sync mode.

I have an MP40 and an MP10 successfully connected to the WXM.
At first I had each pump running in his own mode but decided now to run them in sync mode.
I tried to follow the instructions from the excellent "unofficial guide" but it seems not to work.

What I did:
I created 2 profiles.
Called the first one "sync40" for the MP40 and used Vortech Type: sync and assigned as master to the MP40.
Called the second one "sync10" for the MP10 and used again Vortech type: sync and assigned this one (MP10) to the master MP40

Then I did my outlet setup:
I used for the MP40 outlet "advanced" with the following code:

Fallback ON
If Time 08:00 to 11:15 Then Lagoon
If Time 11:15 to 11:45 Then Nutrient
If Time 11:45 to 18:00 Then Crest
If Time 18:00 to 21:00 Then Lagoon
If Time 21:00 to 08:00 Then Night
If FeedD 005 Then Slow
If FeedA 000 Then Slow​

For the MP10 outlet I used "advanced" also and the code:

Fallback ON​

The issue I have is that the MP40 runs in the correct mode as programmed but the MP10 runs in a different mode (actually it is the mode I had programmed before I switched to "sync").

Any thoughts what could be wrong?

Thanks
Michael

 

[RussM]

I think you use sync only on the slave, not both master and slave.

 

[MAXreefer]

I think you use sync only on the slave, not both master and slave.

Thanks for the reply. You made me thinking about this.

I assume you could use BOTH sync profiles just in case you want to switch the master to a slave or the slave to the master.

I think I found what was wrong.
In the outlet setup for the MP10 (slave) I added "Set Sync10". The Sync10 profile just tells who the master is (in my case the MP40).
Seems both are doing the same thing now.

 

[cali9dub]

wouldnt you get the most out of 2 Vortechs by having them anti-sync? I have my 2 MP10's on anti-stnc and it keeps great tank movement as well as wave action during certain settings...

Mine are on opposing sides of the tank, btw.