1.5" threaded Bulkhead - Whos got one?

[sellout007]

Who has one that is close to plainfield. I don't want to drive to far, and I dont want to pay a fortune. I need it to plumb up my new skimmer pump. So who has one? Where you located, and how much?

Im located at 55/weber road.

 

[sellout007]

On a side note, would I be able to use two 1" bulkheads instead? I have several of those lying around.

 

[aiko670]

I'm not positive but I think Jim at Coral Paradise has some.

You may want to call him.

24 E. Northwest Hwy.
Arlington Hts, IL 60004
http://coralparadise.org/

Phone: (847) 632-1779

 

[whiirly]

try Farm & Fleet in Oswego

 

[sellout007]

<a href=showthread.php?s=&postid=7438210#post7438210 target=_blank>Originally posted</a> by aiko670
I'm not positive but I think Jim at Coral Paradise has some.

You may want to call him.

24 E. Northwest Hwy.
Arlington Hts, IL 60004
http://coralparadise.org/

Phone: (847) 632-1779

50 min away, a bit to far for me. Ive got a buddy up in Algonquin that has one, and thats about the same drive. And I know Rod has one as well.

Was trying to find someone thats 20 min away or so. I know there are alot of reefers around Plainfield.

 

[sellout007]

<a href=showthread.php?s=&postid=7438239#post7438239 target=_blank>Originally posted</a> by whiirly
try Farm & Fleet in Oswego

Not sure where that is. MSN says oswego is 30 min away. That might be a possability. Do you have their address?


*edit*

Found their website, I think, and there is no store in oswego. The closest one is Montgomery. 26m away. Not to bad.

 

[rickyb]

I don't think they sell 1.5" threaded both sides bulkheads, at least not the standard ones. Any place they sell ponds may have the oversize ones. I was looking all over for some and wasn't able to find any, so I opted out for the slip X thread.

 

[Rod Buehler]

farm and fleet only has 3/4 (Oversized and fits the same hole as a 1" bulkhead) 1 1/4, and 2" bulkheads). They dont carry 1" or 1.5s

 

[sellout007]

Well that saved me a trip.

Rod, would I be able to use two 1" bulkheads and combine them?

 

[MARSHALL MANN]

i have 1 1/2 bulkheads if you need 1

 

[Rod Buehler]

<a href=showthread.php?s=&postid=7438658#post7438658 target=_blank>Originally posted</a> by sellout007
Well that saved me a trip.

Rod, would I be able to use two 1" bulkheads and combine them?

is this for a suction/feed line to the pump? What skimmer and what pump are you using?I dont think that you can move as much water through (2) 1" pipes as you can through a 1.5" pipe, (but I am no engineeer, or mathimatition ),especially if you have to use elbows and such.