120v home switch panels, where?

[Bent]

I checked amazon and a couple other places but can't really find what I'm looking for.

In my salt mix bucket I'm going to have 3 power heads, a heater, and a pump to pump the new mix to the sump.

I'd like to find a way to mount a control box with switches and make it all look clean. Where can I get one?

 

[Curtis1]

E-Bay, Chauvet PC 08 , check it out, it's a DJ's power strip. Led lights on each switch.

 

[Bent]

Awsome I'll look for it

 

[Bent]

This?
http://bit.ly/1jmGDY5

 

[Vinny Kreyling]

That will work!

 

[Bent]

Ordered!

I'll probably take a jigsaw and cut out a hole in the front of the stand and mount it there, under the top can.

 

[Vinny Kreyling]

Why 3 powerheads?
If you just want to mix run a tee off the line to the tank with 2 valves & done.

 

[uncleof6]

I don't see much need for all the "fancy" either. Unless the water is oversaturated with salts, the salts are not going to settle out of solution, making powerheads a little bit much for other than initial mixing, if that. I also raise an eyebrow on the heater...unless your water temps are dipping below 70°F or more.

 

[Bent]

Well, couple of reasons for doing it this way.

I need the heater because down in the basement it is cold. I brew quite a bit of beer down there and trying to brew ales on the warmer side, 72-75D, is a chore. I had to run a swamp cooler (fermenter sitting in a large cooler with a aquarium heater and water. Heat the water up with the heater and the fermenter heats.) until I could build an appropriate fermentation chamber. So temperature control down there is extremely important. Otherwise it will be something I'll be fighting with.

Now, changing up the plumbing to mix it with the transfer pump is a great idea. I believe I'll change the plan up and do it that way! Thanks for the suggestion!