2 Questions

[b_vanfossen]

1- with the mounting type design on the sides of the WWD- what is the preferred method of mounting it? There is nothing on this in the manual...

2- I'm reading that people with 2 mp40w with the slave in antisync mode are having this problem:
when the master is at 20% the slave is only running at 50% power instead of 80%. But when the master is at 80% the slave is at 20%. Is it suposed to do that?
They are saying that when they are both in sync mode then the slave will run at the full 80% or 100% but the slave will not run in the higher %'s in antisync.

Thanks

 

[mrcrab]

The holes on the side are screw holes. You can mount the controllers with screws. I used velcro on the back of mine and that works very well as I can move them if needed.

Remember to mount them so that they are in line of sight if you have more than one and plan on using them in tandem. They should be less than 10' apart, the closer the better and there must not be anything in between them.

To program them together they must be close together, a couple of feet at most, that's another reason why I like the velcro. If you can mount them so the tops of the units are facing each other, that would be better as the antenaes are on the top of the units.

When in sync, both pumps should be running at the same speed.

When in anti-sync, they should be running the opposite of each other.

 

[EcoTech Marine]

mrcrab's got it right!

I also like to use velcro because it allows for you to move the drivers around or remove them if need be.

As far as the problems that you are reporting with sync/anti-sync modes, please have your friend who is experiencing this email us at service@ecotechmarine.com with a full explanation so that we can look into it further.

-Tim

 

[b_vanfossen]

thanks mrcrab and ecotech.