6001 Help blinking light

[dtaylor123]

Roger,

I have a pair of 6001's with the 7095 controller, one of the pumps is not working. It was cleaned last week, it worked fine after the cleaning for four days. The light inside the 24V fuse (fuse is not the correct term, I have two options, 24V or 18V) is blinking, either when connected by it's self or into the controller. The impeller doesn't start at all. Hopefully the solution will be easy, but if not please either PM me or give me the address to ship to here. Any information I am leaving out, let me know.

Dan

 

[rvitko]

The pump is likely dead unless maybe a piece was left out or not cleaned. The blinking light means the power supply is overloaded.

Send it to:

Tunze USA
305 Victor St
Austin TX 78753

 

[dtaylor123]

Thanks for the quick reply. No pieces were left-out, it was working fine after I cleaned it, it was never noisy and the impeller was seated properly, as far as I could tell. I will send it out tomorrow, thanks again for the awesome service that you give to us customers. Just send the pump, correct?

Dan

 

[rvitko]

Send the pump and power supply. I would like to check both.

 

[dtaylor123]

Once again Tunze and Roger came through. Even though their excellent service could be taken for granted, I don't and I always appreciate the awesome customer service.

Dan