Roger,
I've had a 6025 running for about 3 months now. A month ago in the process of replacing it 2 of the 4 tabs that hold the c-clamp attached to the magnet broke. Luckily, the 2 that didn't break were on opposite sides/corners so I've still been able to use it. Today I took it out again to clean it and one of the two remaining clamps broke, and when I finally got it positioned so I could plug it back in, the prop is shuttering and wont start.
After reading some of the other thread son here, I'm assuming I have one of the older models since mine has a flat cord instead of the newer ones with the round cord.
What are my options on getting a new clamp and getting the unti repaired/replaced sir?
Thanks in advance for your time,
Rob Hagemann
I've had a 6025 running for about 3 months now. A month ago in the process of replacing it 2 of the 4 tabs that hold the c-clamp attached to the magnet broke. Luckily, the 2 that didn't break were on opposite sides/corners so I've still been able to use it. Today I took it out again to clean it and one of the two remaining clamps broke, and when I finally got it positioned so I could plug it back in, the prop is shuttering and wont start.
After reading some of the other thread son here, I'm assuming I have one of the older models since mine has a flat cord instead of the newer ones with the round cord.
What are my options on getting a new clamp and getting the unti repaired/replaced sir?
Thanks in advance for your time,
Rob Hagemann
