6080 Impeller

[marioensf]

Have couple 6080's that need new impeller assembly, what would be the part number (s) for them and is it the same as the 6100?

Thx

 

[rvitko]

They use different drive units that should not be interchanged. The 6080 uses a 6080.600 drive unit and if you need the propeller blades themselves they are 6080.120 and are not included, this drive unit is used on the 6060, 6080 and 6130 and the blades are the only difference so they are sold seperately. The 6000 and 6100 use 6100.700 and this includes the blades.

 

[marioensf]

Most likely I'll order the complete assembly for one 6080, got couple of them bundled with some stuff I purchased a while ago and both impellers were stuck, one came out OK but the second one the magnet broke and have to get it out; half of it is still inside. Any suggestions on how to pull it out?
The one 6080 that I was able to take the driver out seems to work just fine after a long vinegar bath.
Thx for the help.

 

[rvitko]

The best solution is an autobody dent puller, it is a small slide hammer with a screw on the end that you will thread into the plastic in the center of the magnet, second best is to use a 3" #10 deck screw and pull and twist it out with vice grips, you may need a friend to hammer on the vice grips and help pop it out while you hold the pump over the end of a bench with a soft cloth under it.

 

[marioensf]

Tried that route, one came out the otherone the magnet broke and half of it still iside stuck; anyway it will keep me busy trying to get it out.

Can I place the order for the replacement parts with you?

Thx again !

 

[rvitko]

You can order them on tunze.com and those orders come directly to me.

 

[marioensf]

Will do, thanks again.

BTW the 6025's are working flawless !!